jeffhill5333 jeffhill5333
  • 04-07-2022
  • Engineering
contestada


What is the first test you should do when checking the charging system?

Respuesta :

jamesscotts
jamesscotts jamesscotts
  • 04-07-2022

Answer:

Connect the test light in series with the negative post, and start pulling feed wires. The first to check is the heavy charging wire from the alternator. A bad or leaky diode in an alternator is a very common source of overnight battery drain. Connect wires one at a time to see what lead is drawing current.

Answer Link

Otras preguntas

What did the policy of internment reveal about the United States? What were the impacts of internment on Japanese Americans in the years and decades following t
A Narrative essay on I wish I had listened to my mother ​
WILL GIVE BRAINLIEST FOR QUICK ANSWERS!! I RATE WELL FOR GOOD ANSWERS!!
1. Explain what is meant by each of the marketing concepts, by completing the table below: Marketing concept Description Production Product Selling Societal
The perimeter of a rectangle is 80x. The base is two times the height. In terms of x what are the dimensions of the rectangle
A spy realizes his cover is blown and flees toward his secret evacuation spot at a speed of 60 mph. Two hours later, a special agent in a helicopter starts chas
1. Explain what is meant by each of the marketing concepts, by completing the table below: Marketing concept Description Production Product Selling Societal
answer this question faster
The molar concentration of NO3− ions in a 0.054 M solution of Ca(NO3)2 is ______
Round 3.75 to the nearest hole